DragON Jet 2 smoke generator with DragON Air electric pump

The smoke generator is equipped with an electric pump with a power of 5W and a productivity of 2x3.5 L/min.

The generator can be installed in both large and small smokehouses. Tests were carried out with a 300 liter smokehouse.

The smoke generator can be installed on both sides of the smokehouse, depending on your needs.

Smoke generator with ashtray - adapted to the needs of home smoking enthusiasts. The use of a smoke generator ensures excellent quality and efficiency of the smoking process.

Universal stainless steel smoke generator suitable for any smokehouse - this weatherproof smoke generator can be installed in a steel, wooden or brick smokehouse.

Innovative nozzle - its correctly cut end design, special angled tube and attached pump ensure perfect, even smoke discharge in the smokehouse and provide high efficiency with low wood chip consumption.

Easy assembly and disassembly - the design solutions used allow you to quickly and easily connect the generator to the smokehouse and prepare it for operation.

Spacious body (tube) - allows you to insert approximately 450g of wood chips for smoking into the generator (recommended chip fraction size 8-12 mm). Such an amount of chips allows you to smoke for several hours without the need to add additional chips.

Easy cleaning - the smoke generator can be easily disassembled and cleaned without unscrewing its base from the smokehouse and without using any tools.

Thanks to an efficient electric pump with variable air flow, optimizing the efficiency of chip burning, you can forget about unburned wood chips!

By placing the pump on a special mounting base, the vibrations it generates are transmitted directly to the combustion chamber, thus improving the shedding of chips during combustion.

The pump power can be adjusted using the switch and pressure relief valve handles, adjusting the amount of smoke according to the needs and volume of the smokehouse.

Attention! Only dry wood chips may be used (maximum moisture content must not exceed 11%). Using wood chips that are too wet may interfere with the proper functioning of the smoke generator.

Cleaning: After each smoking session, clean the generator, especially its interior, so that it is fully ready for the next use and ensures proper smoke flow.

Kit includes:

- wooden lid

- stainless steel smoke generator AISI304 cylinder (smoke supply housing)

- ashtray and tray with handle (stainless steel)

- electric pump (5 W)

- smoke generator nozzle with angled pipe

- stainless steel mounting base

- connection set (silicone hoses)

- stainless steel washer M8 - 4 pcs.

- stainless steel screw M8x40 - 2 pcs. (up to 3 cm wall thickness, in case of greater thickness, appropriate screws must be selected)

- stainless nut M8 - 2 pcs.

- manual

- package with wood chips

Dimensions of the smoke generator when assembled:

Height: 383 mm

Width: 153 mm

Length: 362 mm

Chimney diameter: 20 mm