TDS meter - Temperature and Water Monitoring Device

Suitable for measuring any type of water:

- Tap water

- Bottled water

- Filtered water

- Aquarium

- Spring water

What this device measures: TDS (Total Dissolved Solids) - the total amount of dissolved materials, expressed in PPM (parts per million).

The device does not measure individual ions or chemical compounds, but the sum of all dissolved substances.

Materials that can contribute to the TD value include, among others:

- Cations: Calcium (Ca), Magnesium (Mg), Potassium (K), Sodium (Na)

- Anions: Carbonates (CO3), Chlorides (CL), Sulfates (SO4), Nitrates (NO3)

Detection range: 0 ~ 9990ppm

Accuracy: +-2% full scale

Calibration: factory calibrated

Auto shut-off: 5 minutes

Operating temperature: 0°C-50°C, 32°F-122°F

Power source: 1 x 3V CR2032

Operation instruction:

1) Remove the protective cap

2) Press ON/OFF button to turn the meter on. The tester will read "000"

3) Immerse the tester in the water no more than 2 inches

4) Wait for the display to stabilize. The tester automatically compensates for temperature variations. Once the readout stabilizes (10-30seconds), press the HOLD button to view out of the water.

5) Press the ON/OFF button again to turn off the tester. The tester will shut off automatically after 5 minutes of non-use.

6) After usage, shake off the water from your tester or clean it with clean tissue. Then put the protective cap back on and insert it back into the sleeve.

Instruction included (in english)